FAQ

I accidentally loaded the unsupported version of PacketWise on my Packetshaper 12000; how do I recover?

FAQ ID:    FAQ1137
Version:    1.0
Status:    Published
Published date:    11/19/2010
 

Answer

Packetshaper 12000 requires 8.6.3 or above to boot. If the PacketShaper is unable to boot successfully due to an improper image version, you must revert to the backup image of PacketWise, which is the image previously installed on the unit before you loaded the recent image.

The recovery procedure must be performed from a console connection:
 

  1. Using a null‐modem cable, attach a workstation or PC to the unit’s port labeled CONSOLE. This cable offers both 9 pin and 25 pin connectors on each end.
  2. Start your terminal emulation program (such as HyperTerminal).
  3. Verify that you have configured the program with the following values to communicate with the unit’s console serial port:
    • 9600 bps, 8 data bits
    • 1 stop bit
    • no parity
    • hardware flow control

    Note: If you are using a modem connected to the serial port, the modem must be set to: 9600 bps, 8 data bits, 1 stop bit, no parity, auto‐answer (usually ATH1 in the standard Hayes command set), and DTR always on (usually a DIP switch setting). Check the modem manual for details.
  4. Power cycle the PacketShaper.
  5. As the unit is attempting to boot, (the message Loading... appears in your terminal emulation program), press Ctrl+B. This forces the PacketShaper to reboot using its backup image.


 


Rate this Page

Please take a moment to complete this form to help us better serve you.

Did this document help answer your question?
 
 
If you are finished providing feedback, please click the RATE CONTENT button. Otherwise, please add more detail in the following text box and then click RATE CONTENT.
 
 

Your response will be used to improve our document content.

Ask a Question